where is the speed sensor for the transmission located in 2001 chevy venture
It is probably the speed sensor. It is located on the transmission and sends an electrical signal to the speedometer.
Where is the camshaft sensor located in 1997 Chevy venture
On a 2001 Chevrolet Venture with a 3.4L engine, the transaxle system sensor, often referred to as the transmission range sensor or neutral safety switch, is typically located on the side of the transmission. It is mounted on the transmission case and connected to the shift lever mechanism. This sensor monitors the position of the gear shift and ensures the vehicle only starts in park or neutral. Always refer to a repair manual for specific details and diagrams for your vehicle.
It is located in the back by # 6 cylinder on top of the motor between the heads.
where is the transmission speed sensor located on a 2005 ford taurus
The crankshaft positioning sensor is located between the engine and the transmission about one third way down looking from inside top of engine. It is not easy to find. You are looking for a connector wire with the sensor, it is bolted onto the transmission with a 10MM bolt.
The camshaft sensor on a 2001 Chevrolet Venture is located behind the rear bearing cap. It monitors the rotation of the camshaft and updates the computer constantly.
The speed sensor is located on the top of your transmission. You can see it pretty easily by just climbing under and looking for it.
speed sensor is located on the top of the diff housing not on the transmission
i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).
Is located on the back of the transmission. The output sensor is contained in a rectangular box. The sensor should be labeled as such.
The automatic transmission temperature sensor, on your 1990 Mitsubishi, is located on the top of the transmission. The sensor will have to electrical wires going to it.