11 ft lbs
It is between the upper and lower intake manifold. The gasket is an o-ring type.
lower intake is 132 lb's upper intake is 89 lb
I FOUND THIS AT WWW.AUTOZONE.COM, CLICK ON VEHICLE SPECS . For your 1999 CHEVROLET TRUCK BLAZER 2WD: INTAKE BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE LOWER MANIFOLD BOLTS TO 27 IN/LBS TORQUE LOWER BOLTS TO 9 FT/LBS TORQUE LOWER BOLTS TO 11 FT/LBS TORQUE UPPER MANIFOLD BOLTS TO 44 IN/LBS TORQUE UPPER MANIFOLD BOLTS TO 7 FT/LBS (TO TORQUE BOLTS & NUTS, START IN CENTER USING CRISSCROSS PATTERN)
Lower intake manifold bolt 115 in/lb. Upper intake manifold bolt 18 ft/.
torque specs are lower intake 115in-ibs upper intake 18ft-lbs
AnswerIf this is the V-6, then you must have a common problem...lower intake leaks coolant.The torque spec for the lower manifold is:First pass: 60 inch poundsSecond pass: 110 inch poundsLast (outer bolts only): 18 foot poundsUpper intake is a total 88 inch pounds in at least two steps.Randy
Look at the lower rear of engine
The lower intake is 10 ft lbs the upper is 18ft lbs. If you go to autozone.com and read there specifaction area its listed there. That's were I found it!
you dont. go get a 2 wheel drive if your going to lower it
Cylinder heads require 33 ft #s & 90 degrees following... Lower intake is 115 inch #s. Mitchell On Demand states 44 lbft & 95 degrees for 1999-2003 Chevy Malibu cylinder head torque specs for V6 3.1L, lower intake manifold 62 inlb then 115 inlb tightening in a circular pattern starting from center.
hiill
there is no lower intake gasket, only a front and rear gasket