0
What else can I help you with?
How do you repair a no compression in the number 2 cylinder of a 2003 Pontiac grand am?
No compression could mean a blown head gasket, cracked head or cylinder.
How do you know if the number 1 cylinder is on the compression stroke?
To determine if cylinder number 1 is on the compression stroke, you can perform a few checks: First, remove the spark plug from cylinder number 1 and put your finger over the spark plug hole while manually rotating the engine using a wrench on the crankshaft. If you feel air pressure pushing against your finger, the cylinder is on the compression stroke. Additionally, you can observe the timing marks on the crankshaft and camshaft; they should align according to the engine's specifications when cylinder number 1 is at the top dead center (TDC) on its compression stroke.
What if your 05 corsa has had new timing belt new cylinder and valves but still no compression in number one cylinder?
Check the Piston Ring.
Does the rotary button on a 305 always have to point to the number 1 cylinder when it is at TDC on the compression stoke?
WHEN INSTALING THE DISTRIBUTOR THE ROTARY BUTTON HAS TO BE POINTING AT THE NUMBER 1 CYLINDER AT TDC
What causes a number 1 cylinder to have 50 psi and the others 150 psi on a 92 geo prizm 1.6l?
Remove number one spark plug and squirt some motor oil into the cylinder. Now do another compression test. If the compression goes up considerably in number one cylinder you probably have bad/worn or cracked piston rings. If the compression doesn't change much you probably have burned or bent valves.
How do you check the cylinder compression 5.7L Mer cruiser?
Remove the spark plug for each cylinder and screw a compression tester in it's place. Crank the engine around a few times and record the highest number achieved.
What is the 350 Chevy number one cylinder and what is the number one on distributor cap?
Number one cylinder is located driver's side front of engine. With the # 1 piston at TDC on the compression stroke, the rotor will be pointing at #1 plug on cap.Number one cylinder is located driver's side front of engine. With the # 1 piston at TDC on the compression stroke, the rotor will be pointing at #1 plug on cap.
What to do 02 Nissan Frontier 4-cylinder computer says number one cylinder missing it is noticeable at 1800 to 2000 rpm Changed plugs wires cap rotor adjusted valves and compression is 200 l?
check the compression
Why is your engine not firing on number four cylinder after changing all ignition parts?
check your compression on #4 cyl
Dodge Dakota number 2 cylinder not firing changed wires and plugs still number 2 not firing?
Run a compression test on #2 cylinder. You either have a burnt valve or cracked head.
How can i repair a 1996 350 number 4 cylinder misfiring compression in cylinder is 118lbs the rest are about 160lbs?
sounds like your engine needs a valve job worn piston rings would also cause low compression ,but not cause the backfireing
Does the rotary button have to point to the number 1 cylinder with the number 1 cyl at top dead center on the compression stroke of a dodge 5.2?
Yes
