You have to remove one bolt at bottom of front mount. Will look like a round sleeve. Easiest to get to through wheel well.
The lighter module on a Pontiac Bonneville can be removed by unscrewing the mounting hardware. The lighter will then be able to be pulled off the center console.
The fuel pump relay in a 1997 Pontiac Bonneville is found under the hood of the car in front of the wiper blades. To access the pump relay, there is a plastic cover with three tabs which must first be removed.
You have to remove the bottom bolt and spacer for the motor mount. Easiest way is to take the right front tire off, remove the inner fender well access flap. The bolt has a nut on the out side that has to be removed. Then the stud that goes through the mount into the engine has to be removed. Slip the belt over the pulleys and reverse the procedure. Thirty minute job.
The Pontiac Bonneville cost $5,000 when it was first produced in 1957. At that time it was a convertible and had many standard items that were generally items that were optional and that pushed the price up to the range that was similar to that of a Cadillac. The following year they removed many of the luxury items and lowered the cost to $3,000.
I would flush the cooling system with the heater on, thermistat removed, then rinse and put regular green coolant in it.
removed thermostat on 98 Bonneville and also removed rubber seal -- cannot get the old seal back into the housing.... help
Try going here it will tell how to do it what needs to be removed http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800b2052
The fuel pump is mounted dead center of the fuel tank. The tank must be removed in order to replace the pump.
The dash does not need to be completely removed. The side kick panels need to be removed, then the dash screws loosened. the Dash can be shifted to get to the heater core.
in a 94 Bonneville it's under the hood, passenger side. In a 95 it should be the same ttl there is one under the hood, under the drivers side dash and another on the passenger side under the dash. you have to remove the bottom cover on the passenger side fuse location should be on the cover you removed.
You can remove your serpentine belt by loosening the tensioner pulley. Pushed the tensioner pulley to the right and the serpentine belt can be easily removed.
The serpentine belt can be removed by using a rachet/socket and turning the spring loaded tension pulley clockwise. Reverse the order to install the new one. (The pulley should be somewhere in the top/middle section of the drive area.