The bar is called the stabilizer bar and the small rod at each end are called stabilizer bar links. The stabilizer bar links attached the stabilizer bar to the lower control arms. This assembly reduces vehicle roll during cornering.
This is good information for you, call Strutmasters they can help you with any of your suspension needs on this vehicle.
The horn on a 2006 Ford Explorer is typically located in the front of the vehicle, near the radiator and behind the front grille. It is mounted on the driver's side, often attached to the frame or the front bumper support. To access it, you may need to remove the grille or other components, depending on the specific configuration.
It's located under the driver side attached to the Frame just in front of the O2 Sensor , special tools are required to remove fuel lines
Sometimes called A-Pillar
The Vehicle Identification Number (VIN) on a Polaris 400 Explorer is typically located on the frame of the ATV. You can usually find it near the front of the vehicle, on the right side of the frame, just below the handlebars. It may also be stamped on a metal plate attached to the frame or on the engine itself. Always refer to your owner's manual for the exact location specific to your model year.
The tension rod is attached to the lower control arm and is also attached to the front end frame of the car. It keeps the front wheel Camber aligned.
in front of the right rear wheel attached to the frame
The Figurehead
attached to the frame on the drivers side in front of the rear wheel
passenger side under the front of box attached to outer frame.
If your lower control arms are attached to it it's your k frame
I had a 99 F150 4wd with a 4.6L engine. The filter was located in front of the driver's side front tire, attached to the frame rail.
The VIN number is on the neck of the frame. That is where the front forks and handle bar are attached.