Take inner door panel off and look inside the door and you will probably find a rod off the outside door handle.
To fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2-door, remove the trim and access the mounting screws. Remove the nuts and disconnect the linkage rod by flipping the small clip and sliding the rod out of the handle. Reverse procedure for installation.
Pull the inner door panel off and look inside the door and you will probably find a rod off the outside door handle.
It depends on if its a 2 door or a 4 door. I have a 1997 Cutlass Supreme SL, 4 door, and you can just turn the thingy (technical term) that holds the bulb, pull it out of the assembly, and put the new one in.. 2 door, I have no idea :) You have to change the entire headlamp assembly. Remover the trim ring then the old headlight can be taken out.
It is hidden in the dash on a the passengers side. To locate it u must open the front passengers door.
i think it is under the dash
get a slim jim.
no tank must come out
Look on the drivers side door at the specs decal for that information.
Yes, calla locksmith that can get inside of the guts of the door from the outside and he can "jimmy" the door open, this will probably cost you about $60 to $80 dollars. ***Improvement on this answer! You can get in through the trunk. I have the same car and have had the same problem. Have someone small crawl into the trunk and push through the backseat--on my car (97 Olds Cutlass Supreme) you can push through the backseat on the driver's side and open the doors from the inside.
check your drivers door specification decal fotr the tire size.
if there are no bolts in the door jamb then they are welded in and need to be ground down and new ones welded on
there are two or three capped nuts on the inside of the door the whole black strip from the window to the top of the door is replaced