Could be a faulty pressure sensor. The pressure sensor on many GM vehicles is located on top of the fuel tank attached to the fuel pump/sending unit assembly. It can be changed with the tank in place if you can get your fingers on it. Unplug the wire harness from it and wiggle the sensor straight up and out.
Evap Emission Control System Pressure Sensor Low
PO452 is the name of the error code you are receiving. The evaporative emission pressure sensor mount plug could be disconnected so that should solve the problem.
P0451 - Evap Emission Control System Pressure Sensor Performance Improving my answer - P0451 - intermittant open or short in the fuel tank pressure sensor ( FTP ) or the FTP sensor signal
bad wiring or bad vacuum lines at he FTPS (fuel tank pressure sensor)..location fuel tank itself.live. wrench. learn.
0442 evap emission control system malfunction(small leak detected) 0443 evap emission control system purge control valve circuit malfunction 0450 evap emission control system pressure sensor malfunction 0455 evap emission control system malfunction(gross leak detected) there ya go
dtccode.com : Evaporative Emission Control System Pressure Sensor High Input
dtccode.com : Evaporative Emission Control System Pressure Sensor High Input
Trouble code P0453 means:Evaporative emission control system pressure sensor high input
P0454 Evaporative Emission Control System Pressure Sensor Intermittent. Remove and clean first if no change then replace.
Trouble code P0452 means: Evaporative emission control system,pressure sensor low input
On a 2008 Chevy Trailblazer, the evaporative emission control system (EVAP) pressure sensor is typically located on the EVAP canister, which is situated near the fuel tank. The sensor is designed to monitor the pressure within the EVAP system, helping to detect any leaks or issues. To access it, you may need to remove the protective cover or components surrounding the canister. Always refer to the vehicle's service manual for specific instructions and details.