0
You have yo buy the Ford. Fuel line tool (take the cap off}. it slides in the side of the cupling or filter.They sell plastic ones at auto parts stores. match up the size slie it in and they pop right out don't forse them . But depresserize the system first. The connect has a spring thing in the center the tool pushes out of the way.slide it right down the line into the connect make sure the tool is the same size as the line Good luck Happy New year
What else can I help you with?
Temp gauge not working 1996 e150?
probably the sensor
How to Replace alternator on e150 ford van?
The alternator on a Ford E150 van is replaced by loosing the retaining bolts, removing the belt, disconnecting the wiring harness, and unbolting the alternator. A replacement alternator can then be put into place and reattached.
What Ford radios will fit a 1996 Ford E150?
OPfYll cyendpxecxcl
How do you remove the fuel lines from a 1994 Ford e150 fuel tank?
g7qQLk bviuxdmkojar
Where is the EGR valve located on 1996 Ford E150?
It is located on the Left Side ( facing the engine) by the Alternator.
How do you replace the check engine light bulb on a 1996 ford e150 van?
Remove the instrument cluster.
What would cause roller bearings to fall out on a 1996 ford e150 fan assembly?
Wear on either the bearings or race.
How many oxygen sensors does the 1996 Ford E150 4.9 inline engine have?
I have a '95 E150 and a '96 E250, both are 4.9 straight 6 cyl. One has 1 O2 sensor and the other has 2, one on each half of the exhayst manifold. I believe the 96 has 2. but it is an E250, not sure about the '96 E150.
Where is Turn sign flasher on 1996 Ford E150?
The flasher is located under the dash board on the drivers side in the fuse box.
How do you turn on dome light - 1996 Ford E150 van?
On a 1996 Ford E-150 : Rotate the headlight knob in your dash fully COUNTERCLOCKWISE to turn on the courtesy and cargo lights
How do you install a electric fuel pump on a 2003 E150 econoline ford?
To install an electric fuel pump on a 2003 Ford E150 Econoline, first, disconnect the battery and relieve the fuel system pressure. Remove the fuel tank by unbolting it and disconnecting the fuel lines and electrical connectors. Once the tank is out, access the fuel pump by removing the retaining ring on the fuel sender assembly, replace the old pump with the new one, and reassemble everything in reverse order. Finally, reconnect the battery and test the system for leaks before starting the engine.
Firing order for a 1996 Ford E150 Club Wagon 5.8L V8?
1-3-7-2-6-5-4-8
