how do you program keyless entry remote for 2008 Chevy impala
For the LT it's on page 3-48 of the "Owner's Manual", (relearn remote key) done thru the Vehicle Information button of the Driver Information Center...
how to reset Chevy 2008 hhr keyless remote
How to program a keyless entry remote for 2008 Pontiac g5
How to program a keyless entry remote for 2008 pontiac g5
on a 2006 impala it has step by step instruction, it all has to be done through your radio On my 2008 LT the info is on page 3-48 of the "Owner's Manual" & is done thru the Vehicle Information button...
Replaced the battery in the remote.
you have to go to the dealer
To program a 2008 Malibu keyless remote, first, sit in the vehicle and close all doors. Insert the key into the ignition and turn it to the "On" position without starting the engine, then turn it back to "Off." Repeat this sequence twice, ending in the "On" position, and then press the "Lock" and "Unlock" buttons on the remote simultaneously for about 15 seconds. The doors should lock and unlock, indicating successful programming; you can then test the remote to ensure it works properly.
take it to the dealership
To program a keyless remote for a 2008 Hyundai Tiburon, first, sit in the driver's seat and close all doors. Insert the key into the ignition and cycle it from "Off" to "On" five times within ten seconds, ending in the "On" position. The doors should lock and unlock to indicate successful entry into programming mode. Finally, press any button on the remote to program it; the doors will lock and unlock again to confirm successful programming. Repeat for additional remotes if needed.
I would try a clock repair shop.
Get a multimeter and find any hot wire going to the stereo when key is on.
THE TRUNK RELEASE BUTTON IS ON THE REMOTE IF YOU HAVE POWER LOCK AND KEYLESS ENTRY. THERE IS NO TRUNK RELEASE INSIDE OF THE FOCUS