answersLogoWhite

0

1. Insert an existing programmed working key into the ignition cylinder.

2. Turn ignition to the ON position for 5 seconds, then back to OFF position.

3. Remove the existing key and within 5 seconds insert new key and turn

it to the ON positiion for 5 seconds.

4. Turn key OFF then back to ON. The key is now programmed.

Start vehicle to test key.

User Avatar

Wiki User

15y ago

What else can I help you with?

Trending Questions
Why is the electronic throttle control light on in your 2004 dodge ram hemi pickup? How can you release a stuck latch on the liftgate of a 1997 Dodge Caravan when you have tried pulling latch up and down doing both while lifting handle can you help thanks? What is the weight of a Chevrolet 7.4 liter V8 engine? What is the firing order for a 1988 Chevy S-10 2.8L? What does fuse 16 control under the hood for a 98 crown vic? Why would oil light stay on if oil level is full on my 1989 olds cutlass? What is wrong with your car if you turn the key to the on position and then turn it to the off position and the starter is still cranking? 1956 ford customline specs? What kind of problems with Buick Century? Is there supposed to be an oil slinger on the end of the crankshaft on a 2000 GM 2.4 DOHC motor? There is a hose coming out of the aft side of the front axle differential on my 1994 Jeep Wrangler what is it and where does it go? What size are the front and rear speakers on a 2001 Ford Explorer Sport? Does a Chevy Tracker 2000 have a fuel pump shut off switch? How do you take off your vibrtion damber pully on my 1997 Chevy silverado truck? Where is the oil filter on a V6 3.8 liter? Why is my 2004 Chevy Avalanche squeaking while I drive? Where can you find a car model kit of 1973 monogram quicksilver? Firing order of gm engine for 2003 3.8 liter? Problem filling gas tank on a 2006 ford f 250? You have only low beams on your 1996 infinity Q30 could it be the headlamps itself or a fuse?