Using a screw driver, remove the screws and the clips that are holding the door panel to the door frame. Gently pull the panel away from the frame, remove any wire connectors and remove the panel from the frame.
Open the Driver's door and look at the side of the dash. Remove the side panel panel.
Remove inner driver's door panel number should be on "brain"
Open the driver's side door and remove the panel on the side of the dash. If not there, then the passangerside of the dash.
Check this website. It only goes to 2003 but the difference should be small.
How do you remove the interior rear door panel on a 2004 isuzu ascender?
Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.
The fuse panel for a 2004 Toyota Celica is located under the dashboard on the driver's side. To access it, you'll need to remove the cover panel below the steering wheel. There is also a second fuse box located in the engine compartment, near the battery.
it is under the rear seat, you have to remove them, then remove the carpet and you will see to access panels, i believe the fuel pump is the panel on the driver side.
To remove the driver door panel of a 2004 Jeep Grand Cherokee Laredo, start by disconnecting the negative battery cable for safety. Use a flathead screwdriver to carefully pry off the plastic cover over the door handle and remove any visible screws. Next, gently pry around the edges of the door panel with a trim tool to release the clips, and lift the panel upwards to detach it from the door. Finally, disconnect any electrical connectors before fully removing the panel.
i have a 2004 Toyota tundra double cab i want to remove passenger door panel to tight door handle
You will need to remove the fuse identified as "passenger airbag". the fuse box is located on the driver's side kick panel.