0
What else can I help you with?
2001 Chevy Venture oil pressure switch?
on top of the starter of front of your engine block
Where is the power steering reservoir on a Chevy Venture?
Open the hood.The resevoir is located on the left top side of the engine.
Where is the thermostat located on a 1997 Chevy Venture V6?
follow the top radiator hose to the engine. its under the cover.
Were is the distributor cap located on a 1999 Chevy Venture?
the 1999 Chevy venture does not have distributor cap, he has a electronic module assembly, assembly is module and three coils, they are located on the top of the engine, back in the medium near of the firewall.
Where is the power steering container so you can pour fluid into it on a 2002 Chevy Venture?
On top of the engine, passenger side under the windshield.
How do you remove the three plugs next to the fire wall on 1999 Chevy venture?
Just did my daughters 98. I removed the coil pack on the back top of the engine. The rest was done in the braille method. Feel, but no see. bob
Where is the alternator located on a 1999 Chevy Venture?
on my 2000 Chevy Venture, it's the one that sits pretty much on the top of the belt drive.
Where is the map sensor located in a 1999 Chevy Venture?
The map sensor on a Chevy venture is located under the ignition module on top of the rear cilinder bank. To access it you have to remove the ignition module. It helps a bit if you rotate the engine forward and you can lower the engine for about 4 inch. you will have to unbold the subframe on the frontside, use a hydraulic jack to take the weight and lower it carefully. this gives you the extra space needed to work on it.
Where is the starter coil in a 2006 Chevy Trailblazer?
remove the intake on the top of the engine. they are under it. There will be 6. for a L6 engine and 8 for V8
How to remove engine?
can i pull a chevy caviler motor 1998 2.2 4cylinder from the top or do i have to drop it from below
Where is the thermostat located on 2002 Chevy Venture?
Trace the top rad. hose back to the block. It is right inside there. You will have to remove the throttle body to gain access to the space there.
How do you bleed the cooling system on a 2001 Chevy Venture?
When the engine is cold, remove the radiator cap, top off with a 50/50 mix, and start the engine. This will allow air to escape from the radiator. It may also have bleeder valves located high on the cooling system. The location will be listed in your owner's manual.
