I'm not sure if they changed anything between 2000 and 2002,
but my 2000 window motor has 3 VERY breakable plastic clips that holds the motor in place around the gearbox.
2
4.5 Quarts of oil.
take a flat bar or caw hammer slid under the door cover and pired out
The heater blower motor in a 2000 Oldsmobile Silhouette is located under the dashboard on the passenger side of the vehicle. To access it, you typically need to remove the glove compartment and some lower panels. The blower motor is mounted to the HVAC housing, usually near the firewall. Make sure to disconnect the battery before attempting any repairs for safety.
To replace the passenger window motor on a 2002 Oldsmobile Silhouette, first, remove the door panel by unscrewing any fasteners and gently prying it away from the door frame. Disconnect the electrical connector and remove the old motor by unscrewing it from the regulator assembly. Install the new motor by aligning it with the regulator, securing it with screws, and then reconnect the electrical connector. Finally, reattach the door panel and test the window to ensure proper operation.
Put a potato in the exhaust pipe.
One bolt at a time-cute but not helpful
under dash on right side three bolts
standing at front of vehicle look straight to the back top of motor,
To change the blower motor resistor in an Oldsmobile Silhouette, first disconnect the negative battery cable for safety. Locate the resistor, usually found near the blower motor under the dashboard on the passenger side. Remove any screws or clips securing it, then unplug the electrical connector and pull the old resistor out. Install the new resistor by reversing these steps, ensuring the connector is securely attached before reassembling everything.
Check the ground strap between the wiper motor and the body.
If one takes a look at the schematics of a 1994 Oldsmobile silhouette minivan, one can see a fuse block, washer switch, and windshield wiper. There are also the power input, washer control, motor ground, and circuit board.