0
First off, don't, if you don't have to. The drums can be removed by removing the entire hub assembly by unbolting the 4-13mm bolts behind the backing plate (and by making sure the emergency brake is not too tight).
If you have to however, use a #2 slot screwdriver and a hammer and gently tap the edge of the rim. If the dust cap doesn't free up, you may need to puncture the dust cap by hammering harder on the screwdriver and then prying, but if you are patient and careful this should not be necessary.
What else can I help you with?
What is the spindle nut on 2000 ford focus rear drum brakes?
Nut you see after you remove the dust cover, in the middle of the drum, 30mm socket needed to remove
Does a Ford Focus 1.8tdi have a timing chain?
yes they do have a timing belt . u can check this by removing the cover on the end of the engine,hope this helps
Deactivate Passive Anti-Theft System on Ford Focus?
You can deactivate the passive antitheft system on your Ford focus by removing the antitheft system fuse. The location of the fuse can be found on the inside cover of the fuse box.
What covering the break?
Cover the brakes
What are the benefits of using a bike brake cover for protecting your brakes?
A bike brake cover can protect your brakes from dirt, debris, and moisture, which can help extend the lifespan of your brakes and improve their performance.
What covering the breaks mean?
Cover the brakes
What does covering the break means?
Cover the brakes
How do you remove the mirror cover on a 2006 f-250?
The mirror cover can be removed by removing the mirror cover retaining bolts. You can access the retaining bolts by removing the inside door panel.
How do you run the overhead on a cat 3176 engine with Jake brakes?
You can run the overhead, on your Caterpillar 3176 diesel engine with a Jake brake, by removing the Jake brake. Next, remove the valve cover. Adjust the overhead with the adjustment screws.
How do you change the battery in the Fossil Golf Cart clock?
By removing the cover and then u take out the battery and you put in your new one and that's
How do you remove Rear brake drum from Honda fourtrax ATV?
Depending on the year it could be mounted on the right rear wheel or to the right of the rear axle support. If it is on the wheel, you have to remove the spindle by removing the cotter pin and unscrewing the castle nut, then unscrew the bolts holding the cover to the backing plate, then making sure the brakes are backed all the way off, gently work the drum off using pry bars if necessary. Be careful, the backing plate is aluminum and will break easily. If on the axle, you will have to remove the spindle as above. Then you have to remove the axle nuts that are against the drum cover. If they have never been off, soak them in PB Blaster prior to removal, I have had to use heat on quite a few as well to get them off. Once they are removed, the procedure is the same.
How do you remove brake light cover to change bulb on 2001 Ford Focus ZX3?
How do you remove the brake light cover on a ford focus
