0
take off center finish panel pop out your cigaret lighter bezel and the bottom right bezel should be i-pod or blank bezel even a dual fuel bezel. take out the 2 7mm screws located inside when u pop of the bezels.gently pull panel off.have some one hold this out of your way.try not 2 scratch anything.on your cluster finish panel you have two 7mm screws on the bottom and two on the top.if you have tilt ,tilt it all the way down.you need to have your shift lever all the way down.you need to unplug any bezels that are on your cluster panel.once that's off two 7mm screws hold your cluster in .pull on cluster from bottom then tilt out.
What else can I help you with?
Will a 2008 f250 tailgate fit a f350 2008?
yes
What size of diesel motor dose your 2008 F350?
6.7
Oil filter in a 2008 f350?
.. is going to depend on which engine you have.
Where is the turn signal flasher located in a 1999 ford f350?
Behind center of instrument panel.
How do you replace rotors on 2003 Ford F350?
The rotors on a 2003 Ford F350 are replaced by jacking the vehicle up, removing the wheels, taking off the calipers, and removing the bearing caps. The retaining nut can then be removed, the rotor pulled, and a new rotor put in place.
2008 f350 wheel bolt pattern?
8x170mm Lug Pattern
What is the gross vehicle weight of a 2008 F350 diesel?
look insid of the driver's door.
Where is the power distribution box on a f350 superduty 2008?
behind the engine coolant reservoir.
Where is the blower motor resistor on your 2008 F350 super duty?
Behind the glove box.
What size is wrench for oil filter for 2008 F350 super duty 6.4 diesel?
36mm
Will 2008 Ford f450 dually rims fit a 2006 Ford f350 dually?
Your answer is NO... The F550 & F450 use a 10 bolt patern and the F250 & F350 use an 8 bolt patern.
What year did ford replace powerstroke 6.0?
6.4L Power Stroke Diesel Engine fitted to 2008 - 2010 F250, F350 and F450 pickup trucks and F350 + Cab Chassis SPONSORED BY:
