At the base of the brake pedal you will see the brake light switch. When you find the switch you will notice that it is held onto the rod by retainer clip which can be quite difficult to remove without damaging the clip. Once you get the clip off you can undo the electrical connector and the switch should slide off. Then you can slide the new one on, connect the electrical connector, and re-install the retainer clip.
How do you replace a break light switch on 1995 Chevy Tahoe
you can find the switch on the back of the brake pedal.
Probably a faulty ignition switch. learn more at www.trailvoy.com Trailblazer enthusiasts website.
#1 blown fuse #2 brake pedal switch #3 light bulbs and/or sockets
You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
The 1999 Chevrolet Malibu brake light switch can be found beneath the dashboard, next to the brake pedal. The brake light switch simply plugs in and out.
When the brakelite switch fails it fails to on. Replace the brakelite switch. Located under the dash on the brake pedal arm. You will see a push switch that is released when the brake is pressed. Just replace that switch.
Check the brake light switch on the brake pedal. Might have to replace it.
Trailblazer enthusiasts will cover all the subjects including brake jobs at www.trailvoy.com
It's just above the brake pedal, connected to the brake pedal arm. The switch comes out with two screws and the new one plugs in. But before you replace the switch, check the adjustment.
7.99 at autozone you have to order it .