To replace the distributor on a 1995 Chevy 4.3-liter Vortec CPI engine, first disconnect the battery and remove any components obstructing access to the distributor. Mark the position of the old distributor and the rotor's orientation for proper alignment during installation. Remove the retaining bolts, lift out the old distributor, and install the new one, ensuring it aligns with the marks made earlier. Finally, reconnect any components, the battery, and test the engine for proper operation.
Yes.
In back of engine, on top, just to the drivers side of the distributor.
The 4.9 vortec means that it is a 4.9 liter v8 probably.
A 2000 Chevy 4.8 liter vortec engine usually takes 6 quarts. It truly depends on the vortec engine, usually the standard is between 5-6 quarts to fill the engine.
270 hp
65ft. LBS.
Five
5.7 liter vortec.
5qts
It's at the top rear of the engine near the distributor.
It is about 3 inches long and has a electrical connecter hooked to it. You can find it back by the distributor shaft, just behind it and it is screewed into the top of the engine block.
4L60E / 4L65E transmission.