It's in the owners manual under power door. I believe you pull the fuse under the hood for 15 sec with the overide switch in the off position. ...(roesterman adds...).My power door was opening all the way then closing immediately. I used this method to reset door and it worked! This started happening after I had some body work done to vehicle..maybe they disconnected battery or something. Delay locking was locking doors before slider was closing too. This left the door unlocked. I haven't tested to see if this has been corrected by reset yet.
To reset the power sliding door on a GM Montana or Venture, start by ensuring the vehicle is in gear and the ignition is on. Then, locate the power sliding door switch and press it to close the door fully, if it's partially open. If the door doesn't respond, you may need to disconnect the battery for a few minutes to reset the system. Unfortunately, I can't provide pictures, but you can find detailed instructions and images in the vehicle's owner manual or online forums.
mine has one on the passenger side Yes, it CAN have power sliders on the drivers side and passengers.
The locks are probably on a different circut than the sliding door. You might check the fuse box under the dash .I think it is in the number 2 spot to see if the fuse is bad. Check your owners manual. If that doesnt work the motor for the power door could be bad. Good luck!
Sell the car without power sliding door , and buy one with.
Can you give us some details? What's wrong with the sliding doors? Are they power sliding doors, or manual? power side doors and back lift gate are power. power sliding door not align
I am having this same problem on my 98 venture. Except mine is stuck slightly open and the alarm is going off. I just turned the "Door Ajar" alarm and the interior lights off. But i would liek to fix this, too.
how do you replace power steering hose on 99 chev venture
To open a power sliding door on a Pontiac Montana, you typically need to press the button located on the driver's side door panel or use the key fob remote control. The button activates the door motor, which then slides the door open electronically. If the power sliding door is not functioning properly, it may be due to a faulty motor, wiring issue, or sensor problem, which would require further diagnosis and potential repair by a qualified mechanic.
The power sliding door fuse is located in the passenger side fuse panel to the right of the glove box. You need to open the passenger door, remove the access panel on the side of the dash and consult the layout map on the panel as to which fuse is associated.
Montana Power Company was created in 1912.
Montana Power Company ended in 2003.
It is vary complex. They are around $700 a pop and used ones are about half that. I would recomend taking it in to get replaced. You'll know what i mean after you ruin one