The button should be DOWN , if the button has popped up on the switch the
switch is tripped and no power is going to the electric fuel pump
there is not a reset, also you have to do is get the seats where you would like to have them and then press the memory button again and it should set to the new position.
press the reset button
With the ignition off, press and hold in the trip reset button, then turn the key to the on position, do not start the car. After about 15 seconds the light should flash. release the reset button and turn the key off . That should reset the light
assuming this is the digital clock, you hit the clock button on the dash, followed by the reset button followed by the clock button. at this point, you should be able to hit the clock button to advance numbers, and the reset button to change the numbers you are setting. if its the analog clock, pull on the knob and turn it
Press the STATUS button on the dash, when it gets to AC filter press and hold the reset button.
down
I have a 2002 Lincoln ls and mine is located in the d/s panel by your left foot. Pull the panel and its a red button
The reset button on a Eureka vacuum is typically located on the back of the vacuum cleaner near the motor. It may be a small red or black button that you can press to reset the vacuum cleaner if it has shut off unexpectedly. Refer to the manual for your specific model for the exact location of the reset button.
To reset a Frigidaire oven using the reset button, locate the reset button on the control panel. Press and hold the button for a few seconds until the display resets. This should restore the oven to its default settings.
Unfortunately There is not a reset oil button ( Like the explorer) at least for the 2003 Expedition ( Eddie Bower model)
To reset the Citroën Relay service light for a 2003 model, first turn the ignition to the "ON" position without starting the engine. Then, press and hold the trip reset button on the dashboard. While holding the button, turn the ignition off and then back to "ON" again. Release the button after a few seconds, and the service light should reset.
To reset the service light on a Kubota tractor, first turn the ignition key to the "on" position without starting the engine. Next, press and hold the "Hour Meter" button or the "Service" button, depending on the model, until the service light blinks and then turns off. Release the button, and the service light should be reset. Always consult your owner's manual for model-specific instructions.