Bad oil sending unit, or bad oil pump.
how many miles? if it's up around a 150,000 it could also be worn main and or rod and or cam bearings.
The transmission fluid dipstick is located on the passenger side near the top rear of the engine. With the engine running, remove the dipstick and check the level on the stick.
Inside the fuel tank.
That means the engine is running HOT. Need to check the coolant level and check for coolant leaks.
The truck can hold up to 8 quarts of fuild, but always check the level first before adding more.
You will have to take the transmission pan off of the bottom of the transmission and you will see the filter, Just remove it and install the new one and put new gasket on pan and put pan back on. Fill with 5 qts. of fluid and check level with engine running and hot at a idle on level ground. That's it.
it is the yellow stick coming out of the transmission make sure the motor is hot b4 you check it and on level ground and running not like oil you get no reading from it if it is not running
First, Check for a blown fuse. Second, check for low coolant level. Third, check for clogged heater core, also check lines to the heater core. Fourth, wiring between the switch and ecm (if equipped)
how do you check transmission fluid level in a 2001 chevy metro
Fill it at the same place you check the fluid level.
The transfer case fluid on a 1985 Chevy Suburban should come to the bottom of the filler hose. It must be on a level surface to accurate measure fluid levels.
It is inside of the fuel tank, and mounted on the fuel pump sending unit.
there is RED CAP on the fill hole it will say TRANS FLUID there is a bolt on passenger side you will remove then check while running to see if fluid runs out. pain to do ..