0
What else can I help you with?
What is wrong with a 1991 Ford Escort if the fuel cutout light is on and it will not start even when the cutout switch is pushed?
Check the fuel pump fuse in the fuse block of the engine bay.
Why would fuel cutout light on dash light and cutout switch not tripped and car will not start?
is the cutoff switch a normally open or normally closed switch ? If it a normally closed switch as it should be then the switch will need to activate with the ignition in order to supply fuel. There could be a problem with the fuel cutoff relay or a fuse. Also if you are using a non factory key then this might also happen.
Whats wrong with a 98 Saturn SL2 it will turn over and only start if pushed but okay when warm?
check the slave cylinder for cluch when cold try pumping cluch pedal 4 or 5 times then hold depressed and try to start cylinder is by passing must activate nut switch
Depressing clutch fails to activate starter switch when key is turned to start on 2000 ford f-150?
The F150 uses a safety switch on the clutch system. The switch is under the dash on the clutch pedal arms. If the switch is bad, then the engine will not start.
Why does your brake light stay on 1996 flht harley where do you start looking?
The brake light switch in the hand brake is probably broken or the tab that pushes it is bent. You can also see if your throttle controle is pushed all the way up to the master cyclider.
Why doesn't my 91 ford escort start -- safety switch on clutch when the clutch is pushed extra hard to floor it my start?
put it in neutral then try to start it.
How do you disable an ignition kill switch?
If I remember correctly, an ignition "Kill Switch" is a secret switch (or button) that must be pushed into a particular position for the ignition system to start the car.... That being said.... Simple. If it's a button that has to be pressed for the (key) ignition to start the car, duct tape it in place. Same for a "light switch" switch". OR...you could solder a wire to circumvent the switch..... :) Now remember...if the switch uses a thicker wire....you're going to want to use a thicker wire when you solder it :)
Where is the start button on a suzuki boulevard s40?
...on the handlebar, right hand side. You have to have the push the orange switch forward (top part of switch pushed in), and then 2 buttons below that you have the actual start switch. Also, you must be in neutral and/or have the kickstand UP.
How do you troubleshoot the brake lights for a 1999 Ford Explorer?
start by checking fuses,then at brakelight switch check for power on one wire,should have power.next check power on the other wire with brake pedal pushed down.if you have power check wires from switch to lights if third brake light works fuse and switch ok.
What can I do if my 1993 Ford Escort won't start and the check engine light and the fuel cut off switch light are both on?
Try resetting the fuel cut off switch and see if the engine will start
How do I activate daytime running lights on a 2008 Sienna CE?
To activate the daytime running lights (DRL) on a 2008 Toyota Sienna CE, start by ensuring that the headlights are turned off. The DRL should automatically activate when the engine is running and the vehicle is in gear, provided that the light switch is in the "off" or "auto" position. If the lights do not activate, check the vehicle's manual for any specific settings or fuses related to the DRL system. If issues persist, consult a professional mechanic for assistance.
Why wont my 95 neon start after changing the clutch cable can't even push start it.?
the clutch has to be pushed in to start. there is a switch under the dash probably knocked it out of position. while changing cable.
