answersLogoWhite

0

hey bud hard to answer this since i cant post a picture but when looking at the head with the flat side on the bottom in order from top left to top right the bolts are as followed 5, 3 , 2 , 8 along the bottom is 7, 1, 4, 6, hope this helps it shows the same for right and left Install the new cylinder head bolts. Tighten Tighten the bolts in the sequence shown to 60 N

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you replace head gasket on Buick rendezvous?

How much can cost repair to change head gasket Buick Rendezvous 2002


The front axle nut torque setting is on a 2002 Buick Rendezvous?

192 lbft


What is the torque specs for a 2004 buick rendezvous front wheel bearing?

192 ft/lbs or 260 NM


When was Buick Rendezvous created?

Buick Rendezvous was created in 2001.


What would cause Buick Rendezvous overheating?

It could be multiple problems. check your coolant level, it could also be your Lower intake gasket or even a head gasket.


How do you remove and reinstall heads on a 2002 buick rendezvous?

To remove and reinstall the cylinder heads on a 2002 Buick Rendezvous, first, disconnect the battery and drain the engine coolant. Remove the intake manifold, exhaust manifold, and any attached components, then unbolt the cylinder head using the specified torque sequence. Once the heads are removed, clean the mating surfaces, replace the head gaskets, and reinstall the heads using the correct torque specifications in the proper sequence. Finally, reassemble all components and refill the coolant before testing for leaks.


HOW TO install a starter in a Buick rendezvous?

how to replace starter for a 2002 buick rendezvous


Is there a 2010 Buick Rendezvous?

No; 2007 was the last model year for Buick Rendezvous.


What are the torque specs for a 2004 buick rendezvous front axle nut?

The torque specification for the front axle nut on a 2004 Buick Rendezvous is typically around 150 ft-lbs (foot-pounds). It’s important to use a torque wrench for accurate tightening to ensure proper installation. Always refer to the vehicle’s service manual for the most accurate and specific details.


Does a 2004 window switch for a Buick rendezvous fit a 2002 Buick rendezvous?

Yes


How you change a starter on a 2002 Buick rendezvous?

how do i change starter on buick 2002 rendezvous


How do you replace a starter in a 2004 Buick rendezvous?

how to remove starter on 2004 Buick Rendezvous