0
What else can I help you with?
Mitsubishi L200 cylinder head torque settings?
l200cam caps and rocker shaft torque setting
What are the torque specs on the rod and main caps on a 2 bolt 305?
RODs 45ft-lbs Mains 70ft-lbs
What is the torque specs for the crank bearing main caps and rod bearing caps on a 1999 dodge ram 1500 3.9 liter V6?
Mains 85------- rods 45
What are the torque settings on a 1985 Ford Laser?
torque settings for what? Torque settings for head are 91Nm or 68lb/ft Main bearing caps 59Nm or 44lb/ft Con rod caps 55Nm or 40lb/ft Crankshaft sprocket 128Nm or 95lb/ft Camshaft sprocket 60Nm or 45lb/ft
What is the torque settings for big end and mains on bearings for 800 cc matiz?
the big end bearings torque down at 55 - 65 Nm
What are the settings for the torque of the heads and the main bearings of a 350 2 bolt engine in a '79 Chevy Malibu?
Heads Torque at 65 Ft. Lbs. Mains Torque at 70 FT. Lbs.
What is the cylinder head torque settings for 1.7 D Opel Corsa?
torque settings for mains,big ends and cylinder head Opel Corsa 1.7diesel 2000
What are the torque specs for the main caps and the rods caps on a 71-73 Pontiac 400?
Torque specs for 71-73 Pontiac 400 main cap bolts 100 ft-lbs, rear mains 120 ft-lbs. Rod bolt specs 43 ft-lbs respectively.
What are the torque settings for big end and mains on 3y engine?
For the Toyota 3Y engine, the torque settings are typically as follows: the big end bolts should be torqued to 40 Nm (29 lb-ft) and then tightened an additional 90 degrees. For the main bearing caps, the torque specification is generally around 50 Nm (37 lb-ft) followed by an additional 90 degrees. Always refer to the specific service manual for your engine for the most accurate and detailed information.
What are the main bearing torque settings fiat 1100?
Oh, dude, you're asking me about torque settings for a Fiat 1100? That's like asking a sloth to run a marathon. I mean, who even cares about that stuff? Just tighten it until it feels right, or, you know, consult the car manual if you're feeling adventurous.
What are the torque settings for a land rover discovery dig ends and mains three and a half liter?
The torque settings for the Land Rover Discovery's 3.5-liter engine can vary based on specific components, but generally, for the cylinder head bolts, the initial torque is around 30 Nm (22 lb-ft) followed by a final torque of approximately 90 Nm (66 lb-ft) in a specific sequence. For the main bearing caps, the torque setting typically ranges from 40 to 50 Nm (29 to 37 lb-ft). Always refer to the vehicle’s service manual for precise specifications and sequences for your specific model year.
What are the torque settings for mains and big ends for 1990 Nissan pulsar 1.6?
For a 1990 Nissan Pulsar 1.6, the torque settings for the main bearing caps are typically around 50-55 ft-lbs (68-75 Nm), while the big end bolts should be torqued to approximately 38-44 ft-lbs (51-60 Nm). Always refer to a service manual for the specific engine model and verify with any updated information, as torque specifications can vary slightly based on different engine configurations. Proper torque is crucial for engine performance and longevity.
