0
What else can I help you with?
What are the torque specs for a 2004 5.3 Chevy Tahoe?
What are the torque specs for a 2004 2WD Chevy Tahoe front wheel bearing assembly 5.3 liter engine
What are the torque specs for head bolts on a 2004 Suzuki Forenza?
18 ft lbs in sequence then 90degree in sequence then 90degree in sequence then 90degrees in sequence
What is the torque sequence for manifold to valve cover 2995 Chevy aveo?
The torque sequence for the manifold to valve cover on a 2004-2008 Chevy Aveo (with the 1.6L engine) typically involves tightening the bolts in a crisscross pattern to ensure even pressure. The recommended torque specification is usually around 89 inch-pounds (10 Nm) for the valve cover bolts. Always consult the specific service manual for your vehicle for the most accurate torque specifications and sequences.
1.6 liter Chevy aveo cylinder head torque specs?
2004 chevy aveo 1.6 head bolt torque specs
What is the torque specs for a 2004 Chevy silverado knock sensor?
I found in a google search 15ftlbs torque for the knock sensor.
Axle nut torque spec for 2004 Chevy cavalier?
147 foot pounds
What are the cylinder head torque specs and torque sequence on a 2004 Honda cr85?
I don't have an answer but have you have tried advance auto parts? They are giving me a print out for the same thing.. Good luck.
Why does my 2004 Chevy S-10 shut off when put into gear after starting up?
prob torque converter
How can you tell if a torque convertor is going bad on a 2004 Chevy blazer?
How can I tell if a 1995 torque converter is going bad the tranny slips and stops when it warms up.
Which fuse is for the dome light on a 2004 Chevy Venture located?
who knows. These vans are a rollin joke.
What is the timing marks and torque value on the head bolts of a 2004 Chevy cavalier 2.2 motor?
i need the head bolt torque on a 04 chevi cavallier engine 2.2 DOHC
What is the head bolt tightening sequence and torque for a 2004 forenza?
For a 2004 Suzuki Forenza, the head bolt tightening sequence typically follows a specific pattern to ensure even pressure across the cylinder head. The sequence generally involves tightening the bolts in a spiral pattern, starting from the center and moving outward. The initial torque specification is usually around 22 lb-ft, followed by an additional angle torque of 90 degrees. Always refer to the vehicle's service manual for the exact specifications and procedures.
