LOCATE THE SERVICE FITTINGS Next, you need to locate the service fittings on the A/C system. There are two: a LOW side fitting and a HIGH side fitting. The LOW side fitting is usually located on the suction hose or line that goes from the accumulator to the compressor. The HIGH side fitting is located on the line that goes from the compressor to the condenser. R12 Low Side 7/16 in. threaded ß----------à R134 Low Side 13mm Quick-disconnect R12 High Side 3/8 in. threaded ß----------à R134A High Side 16mm Quick-disconnect On older R12 systems, the LOW and HIGH pressure service fittings are screw-type Schrader valves. On newer R134a systems, the LOW and HIGH side service fittings are quick-connect style fittings. The LOW pressure fitting is SMALLER than the HIGH pressure fitting.
how to add freaon in a 2003 ford escape
Which do i hook to to charge the freon in a 2004 ford expedition
There is one valve that is used to add refrigrant. But you had better not add Freon. Freon is R12 and your vehicle's A/C system does not have Freon (R12) as a refrigrant. More than likely it uses R134a.
Answering "Where do you add freon to your air conditioner in your ford ranger?"
Where does freon go in a 2003 Honda accord
Add more blinker fluid.
Follow Larger hose from a/c compressor--may be near firewall next to drier
it is under the passenger side headlight facing towards the wheel
It is either on or near the recievr dryer in the right rear of the engine compartment. To corrrectly add freon, you need gauges and a refrigerant recovery system
Ask answers.com
How do you add freon to a 96 Ford Contour
add r134a to the service port