when my camshaft sensor was going bad, the vehicle refused to crank after being driven and parked for a few minutes. If you wait a little while it may crank. I heard of people pouring water on the sensor casing to crank them also.
No, there is no camshaft sensor on that model.
On a 2004 Chevy Astro, the camshaft sensor is located in the front of the engine. It is on the left side of the timing cover behind the camshaft sensor.
My 2003 Chevy Tracker would not restart when it was hot and finally would stall & not restart until it sat and cooled off for 10 minutes. It would crank but not start. We replaced the camshaft it solved the problem. It was located at the back of the engine, at the top and is held by just one screw.
The camshaft position sensor on a 2000 Chevy Tracker 2.0 L is typically located on the cylinder head, near the camshaft. It is positioned towards the rear of the engine, close to the timing cover. To access it, you may need to remove some components, such as the air intake or other obstructions, for better visibility and access. Always consult the vehicle's service manual for specific details and diagrams.
where is the camshaft sensor on a 2000 Chevy sliversdo with a 4.8L V8 motor
Symptoms of a bad camshaft position sensor in a 2000 Chevy Astro can include poor engine performance, such as misfiring, rough idling, or stalling. You may also notice decreased fuel efficiency and difficulty starting the engine. Additionally, the check engine light may illuminate, and diagnostic trouble codes related to the camshaft position sensor may be triggered.
Do you have a video of the hhr camshaft position sensor
The 1999 Chevy Suburban camshaft sensor is located on the front of the engine. The camshaft sensor will be behind the front engine cover.
were is the cam shaft sensor
Camshaft position is taken from the distributor, there is no separate sensor.
Where is the camshaft sensor located in 1997 Chevy venture
Replacement of a 2008 Chvy Camshaft Sensor