answersLogoWhite

0

ignition specs four ram 5.9l 10 to 15 degreas advansed dipending on year and spark plug gap 5.9 is al so known to have a inferieor engenerd timing chain sprokit size

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace the ignition timing on a 1987 Dodge Ram 350?

the ignition timing does not get replaced on 87 dodge.


What are the timing specs for '79 Dodge Ram 440?

8 btdc


How do you set the ignition timing on a 1994 dodge ram 360?

The distributor is synched to zero degrees with a scan tool. It can not be done with a timing light.


What is the ignition timing of a 1985 ram royale 5.9 L?

12 degress after top dead center


What is the 1981 Dodge Ram b-250 Van Ignition Timing degree?

Check your underhood sticker.


What is the ignition timing setting for a 1997 dodge ram 5.9l?

The 1997 dodge ram doesn't have adjuastable timing if the. The timing is controled by a crankshaft sensor near the transmission bell housing and a cam position sensor in the distributor. the cam position sensor is uned mostly for fuel injection syncronization. The crankshaft position sensor mainly controls ignition timing and is not moveable/adjustable.


What causes engine pre ignition in 1997 dodge ram 5.2 engine?

check the timing it may be advanced


Can anyone tell me the Ignition timing for 2001 Dodge ram 1500 magnum 318 motor?

It is synced to the crankshaft with a scan tool. It can not be done with a timing light.


What does a 2001 dodge ram use in place of an EGR Valve?

The computer adjusts ignition timing to take the place of EGR.


How do you install timing belt on 1996 dodge ram van?

A Ram Van does not have a timing belt.A Ram Van does not have a timing belt.


Where is the air intake sending unit on a 2001 dodge ram 1500 59l?

It is located on the #2 intake runner, front right side of the air intake.


What is the ignition timing spec for a 1996 dodge ram 1500?

The distributor is not timed with a timing light. The distributor rotor is lined up with the mark in the pick up plate when the crank is at tdc#1. The computer then does all timing from there.