answersLogoWhite

0

The hood decal dimensions for the 1969 Oldsmobile Cutlass 442 typically measure about 24 inches in length and 4 inches in height. The decal features a distinctive design, often including the "442" designation and sometimes additional racing stripes. It's important to note that variations may exist based on specific models and options. Always refer to original documentation or restoration guides for precise specifications.

User Avatar

AnswerBot

3mo ago

What else can I help you with?

Related Questions

How many gallons of gas does a 1969 Oldsmobile Cutlass 442 hold?

22 gals


Will the powertrain 455 rocket from a 1976 Oldsmobile fit a 1969 Oldsmobile cutlass?

The 455 will fit. The transmission might have a shorter tailshaft, though.


How many 1969 Oldsmobile cutlass convertibles were produced?

not near enough cause i don,t own one


How many 1969 Oldsmobile Cutlass 2 door Sports Coupe S post cars or sedans produced?

there were 569 - 1969 Holiday S Coupes made.


Where is the fuel filter on a 1969 Oldsmobile cutlass?

Should be right in front of the carburetor, basically centre of the engine, steel pipe going into it.


Will a 1969 cutlass hood fit a 1968 if it will can you use the gille and headlights and bumper too?

I have a 1969 Oldsmobile Cutlass supreme. My car has a 1968 front bumper, hood, and grill. Its mirror of your question but If a 68 can go on a 69 I wouldn't see why a 69 couldn't go on a 68.


How much freon 134A does a 1969 oldsmobile cutlass s 350 rocket hold?

A 1969 Oldsmobile Cutlass S with a 350 Rocket engine typically holds about 2 to 3 pounds of R-134A refrigerant for its air conditioning system, depending on the specific setup and whether it has been retrofitted for R-134A. It's important to consult the vehicle's service manual or a professional for precise specifications and proper charging procedures.


Is the bolt pattern the same on a 1970s cutlass is a 1969 delta 88?

The bolt pattern for a 1970s Oldsmobile Cutlass and a 1969 Oldsmobile Delta 88 is typically the same, both using a 5-lug configuration with a bolt pattern of 5x4.75 inches (or 5x120.65 mm). However, it’s always advisable to double-check specific wheel sizes and offsets, as variations can occur based on different models or trim levels within those years.


Will a 1970 cutlass front bumper fit on a 1969 cutlass convertible?

No only 1970. 71 and 72 are interchangeable


What general motors drive shafts have the same dimensions as a 1970 Oldsmobile cutlass?

My best educated guess would be any GM A-body car from 1968 or 1969 to 1972, with the same transmission as the subject car. Those cars would be: Chevrolet Chevelle Pontaic GTO Buick Skylark Oldsmobile Cutlass I'm sure there are more to choose from, but without an interchange book, I don't know for sure. One strategy for finding out: Find a local auto recycler (a.k.a. junk yard) and tell them what you are looking for, ask them if they can look up available donor cars and if they have any on their lot. They will have interchange books and can tell you what you need to know.


Where can you buy a 1969 Oldsmobile?

Click the link.


1969 Oldsmobile 98 455 horsepower?

The the 1969 OLDS 98 had 365HP