According to most Oldmobile torque specs, the correct torque for rocker arm bolts is 25 ft-lbs.
The rocker arm torque specifications, for your 1990 4.3 liter Chevrolet engine, is 15 pounds per square inch. The rocker arm should be torqued in five pound intervals.
The torque specifications fourth the rocker arms, on your C 15 Caterpillar diesel engine, is 14 pounds per square inch. The rocker arm should be torqued at seven pound intervals.
For the 1989 Chevy S-10 with the 2.5 liter engine, the torque setting for the rocker arm bolt is 22 ft. lbs. The torque setting for the rocker arm cover is 75-inch lbs.
By removing the valve cover from the engine, then removing the rocker nut on the bad rocker. Refer to a technical manual for torque specifications, as this must be properly torqued!!!
Intake manifold torque specifications for the Olds 403 is listed as 30 ft-lbs.
what bolt?
The rocker box bolt torque specifications, on your Harley-Davidson, is 15 pounds per square inch. The bolts should be torqued in five pound intervals.
The rocker box bolt torque specifications, on your Harley-Davidson, is 15 pounds per square inch. The bolts should be torqued in five pound intervals.
what are the torque specs on a 3.4 s.f.i
There is no torque sequence just torque rocker arm studs to the proper torque
The 1997 Pontiac Transport 3400 rocker arm torque specifications are 18 pounds. The rocker arm should be torqued in six pound intervals.
i need rocker arm torque for 3176 cat