0
when you turn on the key and get no dash lights example check engine or seatbelts. vehicle will still turn over but not fire up. but the dash lights are the key if they come on when you turn the switch and you hear the fuel pump pressure up then the switch is fine. would need to know more of the problem to be sure but this is a good start.
What else can I help you with?
What eles would cause a 96 blazer not to start I changed the starter the starter relay and the neutral safety switch The problem is inertmittent?
Your 1996 Chevrolet Blazer may not start due to a faulty ignition switch. The electronic fuel pump may also be faulty and need to be changed.
How do you change the ignition switch on a 1989 Chevy Blazer S10?
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
What are the Symptoms of a faulty temperature control lockout switch?
what are the symptoms of a bad temperature switch
Is there a reset switch for the ignition system for a 95 blazer?
No there is not.
Is a faulty key switch the same as ignition switch or is it the key lock?
no
Have a 4.3 om cobra boat motor ignition wont start but can jump wires on solenoid and will turn over?
Faulty wiring, faulty ignition switch, or possibly a faulty neutral safety switch.
How can you bypass ignition switch and ad your push button switch for ignition on 1987S-10 4by4 2 door blazer?
Why?
What are the symptoms of a faulty ignition switch on a 2004 buick regal?
My experience with a faulty ignition switch on this generation Regal include random warning lights coming on together and turning off at the same time. Eventually, the car will sometimes stall when the turn signal switch is used. This is due to the turn signal switch "bumping" the wires leading into the ignition switch. Apparently, the wire connections inside the ignition switch sometimes tend to loosen. Dealer cost runs around $350 to $400 to replace.
What causes hazards to go on by themselves on a Chevy blazer?
Faulty hazard switch
How do you replace an ignition switch for a 2000 blazer?
You will need to remove the retaining ring at the top of your 1978 Chevrolet Blazer ignition switch. Slide the ignition barrel out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you know that you need an ignition switch or a ignition coil?
To determine if you need an ignition switch or an ignition coil, you can look for specific symptoms. If your vehicle doesn't start, but lights and accessories function normally, the ignition switch may be faulty. Conversely, if the engine cranks but doesn’t start, or if you experience misfires or stalling, the ignition coil could be the issue. Testing these components with a multimeter can provide further confirmation of their functionality.
What could be the cause of a warning chime on a 1996 Dodge Neon if it is NOT the lights or Keys in the ignition or if all doors are properly closed?
most likely is a faulty chime switch,or a faulty ignition switch
