For lights behind the speedometer/tach warning light area, you have to take the screws out of the panel and then guide it out enough that you can twist it sideways and pull out the burned out bulbs. Replace with bulbs #194 and I would use the Long Life version of the bulbs.
replacing serpentine belt on 2000 chevy prizm need help
Chain
i don't know, as that car does not exist. prizm went to Chevy in 1998.
catalyst system fault
If the brake light in your 2000 Chevy Prizm stays on, it could be due to a few reasons. Common causes include a faulty brake light switch, which may be stuck in the "on" position, or a malfunctioning relay. Additionally, a short circuit in the wiring or a blown fuse could also keep the light illuminated. It's best to inspect these components or consult a mechanic for a thorough diagnosis.
To stop the seat belt light from flashing on a 2000 Chevy Prizm, ensure that the driver's seat belt is properly fastened. If the light continues to flash even when buckled, there may be an issue with the seat belt sensor or wiring. In that case, checking the seat belt connections and fuses could help, or consulting a mechanic for further diagnosis might be necessary.
I clear the check engine light with a Scangauge II. But most ODB-II devices can read and clear the code.
The fuel shut-off switch on a 2000 Chevy Prizm is located in the trunk, specifically on the driver's side near the tail light assembly. It is a small, red button that can be reset by pushing it down. If you're unable to find it, consulting the owner's manual can provide additional guidance.
call a locksmith
yes
I know on my '98 Prizm it is accessible from the inside down low on the passenger side. Not an overwhelming job.
warped rotors , bad brakes,tie rods, tiresbad ,