answersLogoWhite

0

Bad u-joints. Bent driveshaft, Weight that has come off of driveshaft.

A bad dent in the driveshaft.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is viabration?

it a toy that is shaped like a mans penis and it can go into the anus or vagina and it viabrates around causing plesure.


What would cause a knocking when pulling away in a Toyota supra?

it could be the center support bearing in your driveshaft


Front driveshaft rub the exhaust on your wrangler?

Either the exhaust pipe is hanging down and needs to be held up and away from your driveshaft, or the driveshaft is bent and is bowed (probably from traveling fast in 4 wheel drive, putting to much strain on it). which is going to cause it to swing wider and into your exhaust pipe.


Why does your tranny leak at rear seal?

It is possible the seal is just worn out but check the driveshaft u-joints. If a u-joint is bad it could cause the driveshaft to wobble putting extra strain on the rear seal.


How many universial joints on 4x4 1999 cherolet silverado?

there are 4 u-joints 2 for the front driveshaft , 2 for the rear driveshaft and dont forget c-v joint the half shafts cause vibration as well


What could cause drivetrain vibration in a 1974 corvette?

Could be a bad "u" joint, or may your driveshaft isn't balanced.


What cause a 1994 Chevy surburban to shake at 60 mph?

Tires and wheels out of balance. Bad u-joint in the driveshaft.


The driveshaft is found between the?

the driveshaft is found between the?Gearbox and Differential


What could cause a Grinding noise on 1992 ford explorer?

it can be a couple of things such as hubs,driveshaft,u joints or fluid levels


What would cause my car to vibrate when driving between 55 and 70 mph?

unbalanced wheels, or unbalanced/driveshaft good luck


What would cause a vibration from 48mph to 80mph on a 1993 Buick Roadmaster wagon that has new rims tires auto lockout switch u-joints and drums and runs great?

Inspect the driveshaft, look for dents, undercoating or buildup, or driveshaft or companion flange out of balance, check for missing weights on shaft. Try removing driveshaft and reinstalling 180 degrees different.


What would be the cause of an intermittent clicking noise in first gear and reverse in a 1995 Jeep Grand Cherokee?

it is the universal joint front or rear have someone outside vehicle listen to where its coming from front or back. front of driveshaft or back of driveshaft to rear end.