0
The FLASHING light indicates a do not drive situation. This is usually indicative of a misfire. The code will show up and tell you with the use of a code reader. The code will tell you which plug.
Most times it is a bad plug or coil pack. The rich condition created by the misfire will melt your catalytic converter if you continue to drive the vehicle. This is why the light flashes.
For more information visit the Related Link.
What else can I help you with?
Why does the Service engine soon light flash when accelerating but stay lit when coasting in an 2003 trailblazer?
Flashing SEL means do not drive. The cat could melt due to a rich condition probably caused by a misfire. Plug/coil problem. www.trailvoy.com
Other words for fast?
speedy; accelerating; flashing; fleeting; quick; rapid
On a 1998 VW Passat 1.8T my check engine light is flashing and the car is sputtering and running rough indicating a failed catalytic converter O2 sensor or other?
Have vehicle scanned to determine problem
Why is check engine light flashing on 02 jeep wrangler 4.0 on steady then flash's when accelerating and runs bad.?
one of your cylinders is not working.plugs-wires-coil pack
Your overdrive light kept flashing then your 2000 ford windstar se began having a hard time accelerating afterwards it would not drive or reverse whats wrong?
Transmission problem. Take it to a professional.
1998 Toyota tacoma sputtering and engine light flashing?
I just had the same problem on my Tacoma. I ran it through the scanner and it gave me the O2 sensor code. I checked some forums and they all recommended to clean the mass air flow sensor. I checked it, and even though it wasn't dirty, I cleaned it with some mass air flow cleaner (alcohol will do just fine) and the sputtering went away. I also changed the air filter while I was at it. If you have any more questions, feel free to ask me... ElMaliante3701@hotmail.com. Good luck.
Why is flashing-waterproofing called flashing?
Because it is flashed in
How can I install flashing on a deck?
To install flashing on a deck, first, clean the area where the flashing will be installed. Cut the flashing to the appropriate size and shape. Secure the flashing to the deck joists using nails or screws. Make sure the flashing overlaps properly to prevent water damage. Finally, seal the edges of the flashing with caulk to ensure a watertight seal.
Why would a GM truck stop accelerating going down the road wait a few minutes then work again with engine light flashing then will go solid sometimes takes a minute or so before the light comes on?
Sounds to me like you have a plugged or damaged catalytic converter.
How do you get 4x4 to engage on 2003 Chevy Trailblazer?
The selector switch on the dash will allow you to put in 2 Hi 4 AWD and 4 Hi at any time. In order to access the 4 LOW function you must stop and put the transmission into Neutral, then move the selector to 4 Low. When light stops flashing put it back into Drive. Any malfunction will cause the light to flash continually. www.trailvoy.com All the answers for your Trailblazer from true enthusiasts!
Why do you see flashing lights?
the flashing lights are the fireflies or the beetles :)
When was The Flashing Blade created?
The Flashing Blade was created in 1967.
