Chevy went to fuel injection in late 1987 and the carburator was NO LONGER USED.
Yes, it had a Rochester 4-barrel carburetor.
On a 1964 Thunderbird's carburetor, vacuum lines typically connect to several locations, including the distributor for advance timing, the brake booster, and sometimes the emissions system. The specific ports can vary based on whether the carburetor is a two-barrel or four-barrel model. It's essential to refer to a service manual for your specific carburetor model to ensure correct connections and optimal engine performance. Always check for any labels or diagrams on the carburetor itself for guidance.
The model number should be stamped on the barrel just above the trigger guard.
To know the stock OEM carburator you will have to list the year, and model vehicle the carb was installed in. Also is it a 4 barrel or 2 barrel. Is it a 351 Windsor or 351 Cleveland engine.
i have a 95 model and they are carburetor/fuel injected it sounds wierd i have a 95 model and they are carburetor/fuel injected it sounds wierd i have a 95 model and they are carburetor/fuel injected it sounds wierd
The savage models,221,222,223,227,228,and 229 were similar to the model 219,except these models were supplied with a shotgun barrel.(each model listed above represents a different gauge and barrel length).I would try numrich gun parts corp.or E-gun parts.com.
The stock carburetor on a 1987 Jeep Wagoneer with a 360 V8 is typically a Holley 2-barrel carburetor, specifically the model 5RHA2, which has a CFM (cubic feet per minute) rating of approximately 350 CFM. This rating is designed to provide adequate airflow for the engine's performance needs while maintaining good drivability and fuel efficiency.
The cost of Weber carburetor depends on the retailer and the model number. For example a Werber Carburetor Model WK551-38 from Autoplicity costs $386.39.
The 1969 GTO Judge typically came equipped with a Rochester Quadrajet carburetor, which is a 4-barrel carburetor. The standard size for this model was generally around 750 cfm (cubic feet per minute). This carburetor was designed to optimize performance for the 400 cubic inch V8 engine. It's essential to ensure the carburetor is properly tuned for the best performance.
try to put your make and model but specify carburetor diagram for that model that has worked for me several times
The Tecumseh carburetor used in the Mastercraft model 314420515 snowblower is likely the Tecumseh 640084B carburetor. This carburetor is commonly found in Tecumseh snowblower engines and is used in various snowblower models.
If the letters apear on the left side of the barrel above the reciver it will help you scipher the date of manufactor.