answersLogoWhite

0

Probally the crank shaft position sensorid replace that first next would check ignition module under ciolpack

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is The Wiring position for the ignition module on a 1990 Buick park avenue?

what is the wiring position for the ignition module on a 1990 Buick Park Avenue?


Where is the oil plug on your 1990 Buick Park Avenue located?

where is the oil plug on my 1990 park avnue


What is the spark plug firing order for a 1990 Buick Century 330 V6?

For a 1990 Buick Century V6 3.3L engine, the manufacturer's recommended spark plug gap is .060" (1.52mm)


Where do the spark plug wires go on a 1990 Buick Electra Park Avenue?

On a 1990 Buick Electra Park Avenue, the spark plug wires connect to the ignition coil pack and the spark plugs themselves. The ignition coil pack is typically located on the engine, and each wire should be routed to its corresponding spark plug in the order specified by the firing sequence. Ensure that the wires are connected securely and routed away from any hot surfaces or moving parts to avoid damage. Always consult the vehicle’s manual for the correct firing order and specific wire routing.


How do you replace the driver's side mirror on a 1990 Buick Park Avenue?

Just drive it until it falls off, since it's its 1990 Buick. jk, i really dont know.


Where is gas tank located on a 1990 Buick Electra park avenue?

Underneath the car behind the rear axle


How do you remove the bolt on the harmonic balancer of a 1990 Buick Park Avenue?

The bolt is stuck and can't seem to come off.


How can you take the front end off of a 1990 Buick Park Avenue?

You have to know something about what you are doing and take off lots of bolts.


When did Buick stop making electra 225?

Officially, in 1990. 1991 renamed the car Park Avenue with a new body style.


What is a code 42 on a 1990 buick lesabre?

Electronic spark timing. May need module. Need more info.


How do you replace a fuse on a 1990 Buick Park Avenue?

To replace a fuse on a 1990 buick park avenue, open the drivers door, look at the outside edge of the dash, you will see two flat tip screw heads, turned the screws in the correct direction and the screws will pop out. Behind this dash is the fuses and the directory of which fuses belong to what item.The directory will be on the inside of the dash panel.


Where is the fuse for dash lights located in a 1990 Buick Electra Park Avenue?

Open the drivers door and look at the side of the dashboard. This is your access to the fuse box.