The knock sensor just advances and retards the engine timing only. If there is a noise in the engine then you have engine are valve train problems. The knock sensor will not make the engine knock.
That engine has 2 of them and you MUST remove the intake manifold to service the knock sensors.
where is the knock sensor on 2003 kia Sedona answer knock sensor is mounted on the engine block near the intake manifold with a wiring harness attached to it.
The knock sensor on a 2003 Impala v6 3.4l engine is on the side of the block. The sensor is mounted just above the oil filter.
For the exact location of the knock sensor, check your owners manual. There should be a diagram of the engine and all parts.
Knock Knock - song - was created in 2003-09.
To replace the knock sensors on a 2003 Chevrolet Avalanche with a 5.3L engine, first disconnect the battery and remove the intake manifold to access the sensors located on the engine block. Carefully disconnect the electrical connectors from the old knock sensors and remove them using a socket wrench. Install the new knock sensors, reconnect the electrical connectors, and reassemble the intake manifold. Finally, reconnect the battery and start the engine to ensure proper operation.
Under the upper and lower intake manifolds at the back of the engine block.
where is knock sensor on 2003 kia sorrento ex located
on 4 cylinder models,the knock sensor is located on the rear (firewall) side of the engine block below the exhaust manifold..on v6 it is in front (radiater) side of the engine block above the oil filter!!
There's 2 of them on that engine, And there underneith the INTAKE MANIFOLD. You must remove the intake to get to them.
That engine has 2 of them and there both underneith the intake manifold. You can not see are get to them until you remove the intake.