answersLogoWhite

0

front pump or clutches more than likely its the clutches

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What causes 1991 Ford Bronco gear shift to stick in freezing temperatures cannot put car into reverse or drive its stuck until it fully warms up for about 15 minutes?

better look into getting a new cable for it sometimes they get water or rusted inside and makes it difficult to engae till the cable warms


When the air rises does it increase or decrease?

When air rises, it expands and cools, which causes its density to decrease. Conversely, when air descends, it compresses and warms, which causes its density to increase.


What happens when a bottle of boiling water is surrounded by freezing water?

The boiling water cools and the freezing water warms up until they are both at the same temperature.


What happen to the volume and density of an air mass when it cools or warms?

it changes


What happens to air when it is compressed or allow to expand?

It cools, and when it is compressed, it warms


95 jeep grand Cherokee limited 4wheel dr locks in when it warms up and will not release until it cools down?

Viscuous coupling in the transfer case has gone bad.


What would cause your 1991 Isuzu trooper to lose power and then stall after it warms up then it won't start again until it cools down about 10 to 15 min?

ECM


What does land do quicker than water to make local winds occur?

warms and cools


What would cause a 1989 Isuzu Trooper II to lose power and then stall after it warms up and then not start again until it cools down about 10 to 15 min later?

blown head gasket


What causes transmission to slip until it warms up on 92 buick century?

Try to replace the oil filter if the transmission is not engaging when it's cold.


What causes heating of the troposhere?

the heat radiaton warms it.


I have an Eagle Talon TSi 2.0L Stalls after engine warms up and won't start until it cools off Just converted from an Auto tranny to manual?

its the fuel pump check the relays and wiring and then have your try changing your pump.