answersLogoWhite

0

Usually, the biggest cause of a loss in compression is either worn or cracked piston rings, and the only way to restore the compression is by replacing them. Another cause would be a damaged or stuck valve, again you'd have to replace it to remedy the problem.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Why does my Isuzu Rodeo squeaks for 5 seconds after starting?

Check the serpentine belt. If it's loose it will make a terrible noise.


Is Harmonic Balancer Bolt on 1995 Isuzu Rodeo Left Hand Threaded?

No but they are torqued on at 125 to 130 ft. lbs and as a result, very hard to get broke loose.


Your 99 Isuzu Rodeo is leaking fuel. how do you fix it?

First find where the 99 Rodeo is leaking fuel from. Check for loose or cracked fuel lines. The leak needs to be found before driving the vehicle, as the leak could cause a fire.


How do you tighten loose windshield wiper on 1999 Isuzu rodeo?

You are probably going to have to replace the wiper arm. Go to a good salvage yard and get one off a decent looking wreck.


What causes no compression on a brigs and stratton 18.5 hp?

could be a broken valve. or a loose spark plug..


How do you remove the engine from an Isuzu Rodeo when all bolts have been removed and the engine is loose?

its a vague question but i think you need to separate the transmission from the engine they are connected with a splined shaft and they must be pulled straight apart before removing


How do you check the connection from radio to antenna on a Isuzu Rodeo 2001?

A simple continuity test will do, check for continuity from the antenna to the plug. Not much goes wrong with these though I would look at the plug connection at the back of the stereo sometimes they are loose and come apart.


How do you replace lower ball joints on a Isuzu rodeo?

I would like to find the answer to this question as well. I am in the middle of doing just that and I am finding it to be a very involved project because the axle gets in the way of the ball joint removal once you have it all loose and ready to remove.


How do you remove the rear door panel of a 99 Isuzu rodeo?

To remove the rear door panel of a 1999 Isuzu Rodeo, first, ensure the window is fully closed. Start by removing any screws that are securing the panel, usually found near the door handle and armrest. Next, gently pry off the panel using a trim removal tool, being cautious to avoid breaking any clips. Once loose, disconnect any wiring harnesses for power windows or locks before fully removing the panel.


What causes air vent noise in home heating and air conditioning duct?

loose connections or the air being forced into a smaller fitting (compression) then forced through the grille


What would cause f350 6.9 diesel to lose power and have white smoke come out of tailpipe?

blown head gasket,it causes the coolant and gas get mixed in cylinder,that cause the white smokeyou also loose compression which in return you loose power


What is the winding noise in your isuza rodeo?

The winding noise in your Isuzu Rodeo could be due to several factors, such as a failing alternator, worn-out bearings, or issues with the power steering pump. Additionally, it might indicate a problem with the serpentine belt or timing belt if they are loose or damaged. It's best to have a mechanic diagnose the issue to prevent further damage. Regular maintenance can help identify and resolve such noises early on.