There is an electrical failure in the trans and will have to be checked out by a good trans shop. GoodluckJoe
Check your brake fluid level in the brake master cylinder in your engine compartment when it is low your brake warning light will come on
The force that causes acceleration is known as net force.
No a force causes acceleration.
usually it is the overdrive solenoid, but can be the connector to it, input to the computer, or the computer.
Force causes acceleration.
The computer has detected a fault with one of the electronic components and is warning you to run a diagnostic test.
That the force that causes the acceleration is not constant.
Chirping means the brake pads are worn out. That is a warning device built into the brake pad. Replace the brake pads.
The force which causes acceleration towards the centre of a circle is called Centripetal force but what causes it can vary.
Check brake fluid level in master cylinder Check to make sure parking brake is fully released
Acceleration
240N causes= 150a xN causes= 100a X= 240*100\150 = 160N