answersLogoWhite

0

Replace the engine coolant sensor, the one next to the thermostat housing. It could be sending the wrong signal to the ecm that the engine is still cold.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Does a 1990 Chevy silverado 5.7L have a fuel injector?

it has throttle boddy


Where is the fuel pressure regulator on a 1990 Chevy 1500 truck?

It is in the throttle body.


Where is idle speed sensor located on a 1990 Chevy Z71?

If you are looking for the throttle position sensor, it is located at one end of the throttle plate shaft, on the side of the throttle body, opposite side to where the throttle cable is attached.


Is the 1990 southwind Chevy 454 fuel injected?

Yes it is fuel injection. It is called a TBI / Throttle body injection.


Why does 1990 Chevy van dies when put into reverse or drive unless you give it more throttle?

because its a stick shift dumb asses


Where is the egr on a 1990 Chevy 1500 located?

The EGR ( exhaust gas recirculation ) valve is located behind the throttle body on the passenger side.


What is the fuel pump pressure on a 1990 Chevy pick up with throttle body 350 engine?

9 to 13 LBS. NO lower are HIGHER.


What causes a 1990 Chevy Caprice to vibrate when driving?

try new tires and a front end aiighnment.


1990 Chevy Suburban smoke when started?

The most common problem that causes that is Bad valve seals in the head.


What causes low idle on a 1990 jeep Cherokee?

the idle air control motor or iac motor is out. if this is a 4.0 liter, it is located on the throttle body to the left of the throttle position sensor and is removed by removing 2 screws. replace it and plug the new one in. can also cause full throttle condition


Did 1990 Chevy caprices come with fuel injection?

Yes, they all had 2 injectors on the v-6'sv8s and both v-6s. it was called a TBI system. (throttle body injection)


Where is the fuel pressure regulator located on 1990 Chevy lumina?

it is mounted to the fuel inject rail under the top intake manifold should be near throttle body near egr valve