Any colour will do as long as they are conductors.
disconnect the wires underneath the dash and hotwire it
Red is hotwire, black is groundwire, blue is the remote wire or clock and memory, these are your main wires the rest are speaker wires.
Every wire behind the radio is seperately labeled as to where it goes.
under the key switch you will find a few wires cut these and joint them to each other
To locate the hotwire for a 2003 GMC Envoy, first ensure the vehicle is off and the battery is disconnected for safety. You will need to access the ignition wiring harness, which is typically found under the steering column. Carefully remove any covering or panels to expose the wires; the hotwire is usually a red or yellow wire connected to the ignition switch. Be cautious when handling the wires, as improper connections can cause electrical issues or damage.
open hood and found that there is two throttal wires one for cruise control and the plastic mount had broke on the wire
The positive wires for IAT sensor on a dodge ram are the red ones. The black wires are are ones that serve as the negative cables.Ê
No.
For a 1998 Dodge Durango SLT, the color-coded wires for the neutral safety switch typically include a yellow wire, a green wire, and a black wire. The yellow wire is usually for the input signal, the green wire is often the output signal, and the black wire serves as the ground. Always consult a service manual or wiring diagram specific to your vehicle for accurate information.
buy an instalation kit and match the wires color for color
Depends on the year, newer vehicles have more than one ignition and accessory wire. Not to mention anti-theft immobilizers, which make it impossible to hotwire without the correct resistance or RF code. Not only that, but transmissions and other parts can be damaged without 2nd ignition powered. All you have to do though is splice a constant 12V+ wire to all ignition leads and to the starter wire. I recommend using a DMM to test which wires are which. 12 volt.com offers free wiring color codes, check that site. Hot wiring a car in 10 seconds like in the movies is impossible.
The standard color coding for electrical wires in a circuit is red for live or hot wires, black for neutral wires, and white for ground wires.