Place a piece of emery paper on a hard flat surface and rub the mirror base base across the surface
3.3 Camlock Mirror Removal procedure: (Common Method) " Grasp the base of the mirror. " Rotate 90 degrees left or right. " Slide mirror downward toward dash to remove.
there is a set screw in the base of the mirror loosen then slide up
To remove the rear-view mirror on a 2003 Mazda Protege, first, locate the mounting set screw at the base of the mirror. Use a Phillips screwdriver to loosen the screw without fully removing it, which will allow you to slide the mirror off its bracket. Once loose, carefully slide the mirror upward off the bracket, and then you can disconnect any wiring if it has features like auto-dimming. Ensure you handle the mirror gently to avoid damaging the glass or the mount.
To remove the rearview mirror on a 2002 Mercedes ML320, first, locate the mounting set screw at the base of the mirror. Use a Torx screwdriver to loosen the screw, then gently slide the mirror off its bracket. If the mirror has an electrical connector for features like auto-dimming, carefully disconnect it before fully removing the mirror. Make sure to handle the mirror with care to avoid damage.
Rotate the mirror base 90 degrees clockwise and it will release from the base. Then remove the electrical harness. This came from a repair manual. I have not tried it.
To remove the metal button from the rearview mirror stem on a 1995 Olds 98 Regency, first, locate the small set screw on the stem near the base of the mirror. Use a small screwdriver or Allen wrench to loosen the screw, being careful not to remove it completely. Once the screw is loosened, gently pull the mirror away from the stem to detach it. If the button is stuck, you may need to wiggle it slightly while pulling to free it.
To remove the rearview mirror from a 2005 Scion xA, start by locating the mounting bracket at the base of the mirror. Use a small screwdriver to loosen the set screw on the bracket, typically found at the front or side. Once the screw is loosened, gently slide the mirror off the mounting bracket. If the mirror has any wiring for features like auto-dimming, carefully disconnect it before fully removing the mirror.
To remove the rearview mirror from a 2000 Ford Excursion, start by locating the mounting bracket at the base of the mirror. Depending on the type of mount, you may need to loosen a set screw with a Torx or Phillips screwdriver. Once the screw is loose, gently slide the mirror upwards off the bracket. If the mirror has wiring for features like auto-dimming, carefully disconnect the wiring harness before fully removing the mirror.
Just scrape the glue off with a new single edge razorblade. then wipe with alcohol. You are going to have to get the mount out to glue it back on. check for a set screw, if none there is a spring clip holding it in. Use a small screwdriver to push it down while pulling the mount.
To remove the interior rear view mirror from a 2007 Mazda 3, first, locate the mounting bracket at the base of the mirror. Use a flathead screwdriver to gently pry off any plastic cover if present. Next, loosen the set screw (often a Torx or Phillips screw) that secures the mirror to the bracket and slide the mirror off the mount. Finally, disconnect any wiring if the mirror has additional features like auto-dimming.
open the door remove screw holding molding to base of side view mirror. seperate molding from mirror. remove bolt holding top or side view mirror to A-pillar. remove bolts holding bottom side of mirror to A-pillar. disconnect wiring connector.
remove four end caps from metal base below seat ..remove two bolts slide seat remove other two bolts....make sure batttery disconected at least 30 mins before unpluging seat...(airbag in seat)