BAD SENSOR BE CAREFUL SENSOR CAN MAKE AIRBAG DEPLOY It means there is a problem with the SRS. WARNING: This is not a DIY repair. Take it to a professional and have it repaired.
There is a problem with the SRS. Have this looked at by a professional. You may or not have a functioning air bag. It may prematurely deploy or not deploy at all in an accident.
The airbag light in a 1995 262 will come on when there is an airbag circuit problem. The airbag will not work right in the event of a crash unless the problem is fixed.
what does the flashing tranmission light mean on a 1995 Isuzu trooper mean
It is important to understand the meaning behind the warning lights in a car. The Airbag light being on means that there is an issue with an airbag in the car, or with the horn system in the car.
The overdrive off light flashing - indicates a malfunction has been detected
You can't "clear" it unless you fix the problem that is causing the light to be on in the first place. That's the way all airbag systems work.
i have a 96 olds achieva and my high beam light was flashing, i checked the headlights and one of my low beam headlights was out. once replaced the flashing stopped.
A flashing airbag light in a 1995 Geo Metro indicates a potential issue with the airbag system, which could be due to a malfunctioning sensor, a problem with the airbag module, or a wiring issue. It's essential to have the system diagnosed using an OBD-I scanner, as older vehicles like this may not have the same diagnostic capabilities as newer models. Ignoring this warning may result in the airbags not deploying in the event of an accident, so it's crucial to address the problem as soon as possible. Consider consulting a qualified mechanic for a thorough inspection and repair.
A malfunction has been detected , could be a sensor
Check your coolant level...
How do you reset the Airbag warning light on a 1995 Toyota Avalon?
To reset the airbag light on a 1995 Infiniti J30, first ensure the ignition is off. Then, locate the airbag diagnostic connector under the driver’s side dash, which is typically a yellow connector. Short the two terminals of this connector using a jumper wire or paperclip, turn the ignition on without starting the engine, and wait for the airbag light to blink a series of codes. After the codes have flashed, turn the ignition off and remove the jumper; the airbag light should reset. If the light remains on, it may indicate a persistent issue that requires professional diagnosis.