answersLogoWhite

0

You must get the code read from the OBDII port using a code reader or scan tool device. The code will define your problem as reported by the on board computer (PCM) and will almost always give you a solution for the fix immediately.

www.trailvoy.com All the answers for you Envoy or Trailblazer (GMT360 platform)

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the oxygen sensor 2003 gmc envoy?

My car when slow stop engine


Ckeck engine on 2003 gmc envoy?

take to your local dealer for diag.


What is the right spark plug gap for a 2003 gmc envoy?

The recommended spark plug gap for a 2003 GMC Envoy is typically between 0.040 to 0.060 inches, depending on the engine configuration. It's always best to consult the owner's manual or a service manual for the specific engine type to ensure the correct gap. Proper gap settings help optimize engine performance and fuel efficiency.


A diagram of the firing order for a 2003 gmc envoy with a 4.2 liter engine?

Yes


Why is the reduced engine light and service engine soon light on in my 2003 envoy?

There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.


How do you replace the timing belt on a 2003 GMC Envoy SLT?

The 2003 GMC Envoy inline 6 engine does not have a timing belt but a timing chain. No need to replace anything unless the chain breaks.


What does the service vehicle soon light mean on a 2003 Monte Carlo ss?

The service engine soon means the same thing for all cars. It means that you have some trouble with your engine and you should see a mechanic A.S.A.P.


How do you reset the check engine in your car 2003 GMC Envoy?

Have vehicle scanned to determine the problem and have codes cleared


How much oil does a 2003 envoy 6 cylinder require?

The 4.2 liter engine requires seven quarts.


2003 Envoy. Why is the reduced engine power and check engine light on while operating in limp home mode?

have vehicle scanned to determine the problem


Where is Map sensor 2003 envoy?

It should be at the very top near the back of the engine. Just to the right side of the "Vortec" cover on a 4.2 engine.


2003 gmc envoy 4.2L thermostat housing location?

The thermostat housing is on the drivers side of the engine. It is where the bottom radiator hose connects to the engine.

Trending Questions
Oil is in your coolant overflow tank in your Chevy lumina van? How do you replace the dash light bulb in a 2007 Ford Escape? Why would 3 of the signal lights on a 67 mustang work but the rear passenger side signal and brake light not work? What is the bolt pattern for a 1971 f100 5 lug? Does a ford 2001 escape 4-cylinder have a timing belt or chain? Where do you locate the turn signal flasher in a 1995 gmc k2500? At what speed does a Governor cut off on ford explorer 1998? What country is Ford made in? How many valves does the 2006 Cadillac Escalade-ESV have? What motors are available in a 02 Ford Ranger? What do you do if you can not get any lights on dashboard to show and ignition key not all the way in so it will turn but geo tracker will not start turns only? Someone put sugar in the tank of your 1998 convertible sebring jxi What damage could be done Will it hurt your car longterm wise? How long is the 2011 Chrysler Town-AND-Country? Where can you find a diagram to replace the cable attached to the loop to pull the passenger seat up for rear seat access on a 1997 Jeep Wrangler? What carburetor on 1987 Ford 460? How do you replace the spark plugs on a Chrysler town and country? Is the flywheel on a 5.7 liter Chevy pickup a problem starter or flywheel makes high pitched spinning sound.? What is the coolant capacity of a Ford Taurus - Mercury Sable? Will any ford pitman arm fit a Chevy? Where is the emergency flashers button located on your 1982 Mercedes 300 SD?