P0320 (M) No Crank Reference Signal at PCM No reference signal (crankshaft position sensor) detected during engine cranking.
P0320 (M) No RPM Signal to PCM (Crankshaft Position Sensor Signal to JTEC) A CKP signal has not been detected at the PCM.
The Sensor has failed. Replace the *Cam Position* Sensor in the Distributor.
***added by DrStoooopid You're half right. The sensor has failed, but there's two of them.
1. Cam position sensor, which is on the front of the engine. (location varies depending on engine)and is most definitely not in the distributor. There IS no distributor in those engines, they're electronically controlled. The cam position sensor sits .30" from one of the camshafts.
2. CRANK position sesnor which that code is referencing. The CRANK position sensor is the one that failed. (They usually fail in pairs though). The crank position sensor is harder to get to. It's on the back of the engine, near the transfer case.
Trouble code P0320 means: Ignition/Distributor Engine Speed Input Circuit
A 2001 Jeep Cherokee was not built with a cabin filter.
The 2001 Jeep Cherokee has overhead valves (OHV).
The 2001 Jeep Cherokee is a gas-powered vehicle.
no
Diagnostic code 43 in the 1997 Jeep Grand Cherokee refers to an issue with the distributor. This often causes the Jeep to stall at operating temperature.
The 2001 Jeep Cherokee runs on regular unleaded.
The 2001 Jeep Cherokee's turning circle is 35.7 ft..
The height of the 2001 Jeep Cherokee is 5 ft. 3.8 in. (63.8 in.).
The 2001 Jeep Grand-Cherokee has 12 valves.
The 2001 Jeep Cherokee is 13 ft. 11.5 in. (167.5 in.) long.
Jeep Cherokee XJ 1984-1996 should interchange Jeep Cherokee XJ 1997-2001 should interchange