You will need to get a new engine....I had this done on my 1999 tracer...$2000 You will need to get a new engine....I had this done on my 1999 tracer...$2000
Replacing the timing belt on an Interference engine, and doing it wrong, can cause serious problems. Busted piston, bent valve, cracked head, are a few.
bent valve, burnt valve, stuck valve, broken piston ring, cracked piston, cracked head, blown head gasket.
Defective spark plug, plug wire, burnt valve, busted piston, bad rings, blown head gasket or cracked head.Defective spark plug, plug wire, burnt valve, busted piston, bad rings, blown head gasket or cracked head.
Burnt Valve, worn piston rings, blown head gasket, or cracked head.
A piston without compression in a Chevy 350 engine could be due to a broken or worn piston ring, a damaged cylinder wall, a blown head gasket, or improperly seated valves. Any of these issues can result in loss of compression and affect the engine's performance.
Head gasket isn't sealed all the way or a cracked piston if you have one with a bigger engine
Cracked head or leaking gasket. The suction is created on the downward stroke of piston during intake stroke.
it would be better to buy a piston kit. It wouldn't be a good idea to try to fix a cracked piston.
The smoking out one side and not the other is a bad piston ring, a blown head gasket or cracked head it can be one or the other. If the smoke is blue its a bad ring or valve, if the smoke is white its a blown head gasket or a cracked head. Hope this helps you. D.
you might have a cracked O ring that acts as a gasket that goes arounnd the piston (O ring is also known as the piston ring)
bad valve, blown head gasket, warped or cracked head, cracked piston, or failed rings.
It is probably a negative on the head gasket. A head gasket usually lets water into the engine if faulty. Most likely one has a cracked, broken or well worn piston rings. It there is all on all the plugs very possibly the piston rings are worn out and will have to be replaced. Most mechanic work like this should be accompanied by "Miking" the crank shaft and also replacing the rod bearings, saving more expense down the road. However, in the event it is broken or cracked piston rings, most likely they are presently scoring the piston cylinder walls, most serious.