You'd have to make sure that not contaminants or moisture gets into system. Best to replace accumulator/drier at the same time and have system evacuated prior to charging
No the compressors in residential condensing units are called hermetic compressors and have to be rebuilt by cutting open the compressor shell, then rebuild the compressor and then weld the shell shut. Buy a new compressor or condensing unit.
acsuorse.com Try acsource.com
To rebuild an auto AC compressor, start by safely removing it from the vehicle and disassembling the unit carefully, taking note of the arrangement of parts. Clean all components thoroughly and replace worn or damaged parts such as seals, bearings, and the clutch if necessary. Reassemble the compressor using new gaskets and ensure proper lubrication before reinstalling it in the vehicle. Finally, evacuate the AC system and recharge it with refrigerant to complete the process.
Buy a rebuild kit and remove all of the old parts, replacing them with the new ones.
It is a complete rebuild. Replacing all bearings, rings, gaskets, inspecting heads, and replacing water pump, and any other parts necessary.
To unseize or rebuild the AC compressor on a 2004 RX-8, you can start by attempting to free the compressor by applying penetrating oil to the pulley and rotating it manually. If the compressor is irreparably seized, you'll need to replace it, as rebuilding is often not feasible for automotive AC compressors. Ensure to replace the receiver-drier and flush the AC system to remove debris before installing a new compressor to prevent future issues. Always consider consulting a professional mechanic for a thorough assessment and proper installation.
For a full rebuild the engine will be taken completely apart. The cylinders need to be honed, and all internal parts will be checked and replaced if needed.
Completely rebuild.
The cost to rebuild a 2005 Hyundai Elantra engine costs approximately $1,000. This includes dismantling the engine and replacing damaged components.
To rebuild a 1985 Kawasaki 454 LTD, start by disassembling the motorcycle, carefully labeling and organizing parts. Inspect the engine, transmission, and frame for wear and damage, replacing any necessary components like gaskets, seals, and bearings. Clean and rebuild the carburetors, and replace the fuel and oil systems. Finally, reassemble the motorcycle, ensuring all electrical connections are secure and performing a thorough check before the initial test ride.
Reconstruction is necessary after every war to rebuild the society and structures that were damaged by the war.
Yes, you can demolish your own house and rebuild it, but you may need to obtain the necessary permits and follow local regulations and building codes.