51.1811024 thou
remove the spark rail it is held on by 4 13mm bolts and mabe a wiring harness on the rear of the motor is in the way it is an 11mm nut pull the spark rail back and push it down and you can accsess all the plugs with little trouble
your spark plugs are located on the passenger side of the engine. the are located under the coil pack. the coil pack is held on by four 13mm bolts and a wire connector on the rear.
spark plugs are under drivers seat , what a pain but easy . four 15mm bolts on seat 2 on handbrake then lift carpet the rest are 13mm bolts about 10 of them , then remove cover , under that there is three 10mm bolts which holds a plastic cover on which hides the plugs , u will need a 16mm spark plug spanner :O)
spark plugs are under drivers seat , what a pain but easy . four 15mm bolts on seat 2 on handbrake then lift carpet the rest are 13mm bolts about 10 of them , then remove cover , under that there is three 10mm bolts which holds a plastic cover on which hides the plugs , u will need a 16mm spark plug spanner :O)
quad 4? on top of the engine remove 4, 13mm bolts of the coil pack and pull up.the spark plug should be visible
Loosen and move the air intake tube for better access. Remove the three 13mm bolts of the spark plug coil rail. Cut the two zip ties of the spark plug coil rail. Remove the spark plugs with 5/8 spark plug socket. Check the gap on the spark plugs. Torque the new plugs in (22 ft/lbs). Replace the spark plug coil rail and air intake tube. heres a link with more step by step info: http://jeep.us41.org/sparkplugs/index.html
They are right in the front when you open your hood. Four wires go to the manifold, they are in there. Think it's a 13mm spark plug socket and an extension will be needed. It's easy as pie.
Removing spark plugs on a pt cruiser. the throttle body has 3 13mm bolts The throttle body on my 2003 was held to the bracket with only 2 13mm bolts. My 2004 non-turbo has only one. Per a commenter at ptcruiserlinks.com plugs should be torqued to 13 ft/lb +/-2. Per Chrysler, the plugs should be gapped at 0.040" I found the spark plug wires very difficult to remove, but with persistence, I was able to get them off the plugs. Try twisting then back and forth while pulling. There is nothing special about the way they're connected. It's just that the rubber boot seems to adhere to the top of the plug.
when do you change spark plugs
2002 galant , can't find the spark plugs
Take old spark plugs out put new spark plugs in
4.7L has 8 spark plugs. 5.7L has 16 spark plugs.