0
What else can I help you with?
Is there a vacuum hose that attaches to the fuel regulator under the upper intake manifold on a 1996 blazer 4.3 with csfi?
No.
Just rebuilt a 1996 350 vortex csfi engine will not start Think the timing setup correct any suggestions?
Do you have the Correct firing order 18436572
What is the fuel pressure suppose to be on a 1999 Silverado truck with a V6 engine?
The CSFI (Central Sequential Fuel Injection) system calls for 56-62 psi.
What do the letters csfi stand for when used with a 4.3 L vortex Chevy engine?
constant ? fuel injection CENTRAL SEQUENTIAL FUEL INJECTION (LOOKS LIKE A "SPIDER")
Where are the fuel pump relay and the oil pressure sending unit located on a 2000 s10 pickup truck with 4.3ltr csfi engine?
Locating on a 2000 s10 pickup truck: bronzer idea
Where is fuel filter on a 97 Chevy truck standard cab 5.7 liter 350 8-cylinder csfi?
The fuel filter is located on the driver side under the frame just between the wheel and cab.
Where is the throttle body injector on a 1996 Chevy Silverado?
The 1996 Chevrolet Silverado no longer came with throttle body fuel injection. It probably has the central sequential fuel injection system (CSFI) where each cylinder has its own fuel injector.
Will a 1995 s10 4.3 engine interchange with a 1998 s10 that had a 4.3?
The 1995 Chevrolet S 10 4.3 engine will interchange with the 1998 S 10 pickup truck. The motor mounts and the wiring harnesses are exactly the same. The fuel systems may be different. The 95 may have the throttle body fuel injection (TBI). The 98 is probably the CSFI (Central Sequential Fuel Injection).
Why wont1996 Astro Van CSFI engine start when cold?
Sounds like the coolant temperature sending unit (CTS sensor) It detects the current temperature of the radiator fluid and determines whether it should choke the throttle body or not. It usually screws into the intake near the thermostate housing. Trace the top radiator hose to the intake / thermostate housing location and you will see it. Usually has 2 wires going to it.
Are a 95 -96 blazer 4.3 vortex the same?
The 95 4.3 was not exactly the same as the 96' 4.3. In general, the block(casting), the intake, heads are all different. In addition, the oil pan for '96 and up is an aluminum pan, the '95 had a stamped steel. Also the '95 4.3 were either TBI or CPI engines, '96 and up were CSFI engines. These engines are not interchangeable, one will not bolt up to the other and vise versa. Hope this helps.
I have a 1996 Chevrolet 1500 I replaced the fuel pump and the filter still will not start if I dump gas in the throttle body it will fire but will not run what is my next step Thanks?
Possibly something wrong with CSFI ( central sequential fuel injection)system. Or maybe wrong fuel pump installed. If fuel system is TBI (looks like a carb.) then maybe aproblem with fuel pressure regulator. You could also have an electrical issue, check for power at the the fuel pump. Uses a fuse and a relay ( both under hood)
How do you replace an intake manifold gasket on a 97 Chevy 1500?
Hi, am currently doing this job. I am using chiltions full size truck manual, 1988-98. Manual # 28624. This is a pretty good book. Intake manifold section 3-22. What it doesn't tell you is: you must push the csfi through the upper intake manifold. I would be happy to help you in more detail: Call my cell phone anytime. 760-792-2449. It's much easier that way. Simple when ya understand the trick! Ciao! Scott.
