0
What else can I help you with?
Where is fuil sending unit for Ford Contour?
it is under the back seat you need to take off the back seat
What would make a 2000 ford contour sputters like its running out of gas but it has a full tank of gas like its running out of gas but it has a full tank af gas and a new fuel filter?
Could be the servo unit in the transmission. Had the same problem and replaced the fuel pump in our 1999 ford contour but it was the servo unit.
Where is the oil pressure sending unit on a 1995 Ford contour?
under the rubber of the front left tire under the rubber of the front left tire
Where is the flasher unit in a 1998 Ford Contour?
The flasher unit is on the left hand side in the steering column.remove 3 screws on top and 3 on the bottom,with a Phillips screwdriver,push up clip and pull out.
Where is the oil pressure sending unit on a 1999 Ford contour 2.5 L 155 Cid V6 DOHC?
it sits behind ac compressor on the 2.5l
How do you test a eec unit on a 1998 ford contour?
for computer testing, just take it into your local shucks orilly store, and ask them to run a computer diagnostics on it
Why is fluid coming out of dipstick tube on your Ford Contour?
It is possible that the transmission is overfull and the pressure in the unit is forcing out the excess. Also, it is possible that the transmission is overheating and boiling the the fluid.
On a 95 Ford Contour is the ac freon R12 or R134.?
As this was the year of the switch, it can have either. There should be a sticker somewhere on the unit listing what it has. Any A/C professional can tell you.
What is timing and control unit in 8085 microprocessor?
timing
How do you use timing light on ford 390 1964 ford galaxie 500 XL?
Connect timing light in series with No. 1 spark plug Connect timing light to battery Remove vacuum line to vacuum advance unit on distributor Mark timing marks on crankshaft and stationary Loosed distribtor hold down slightly Start vehicle and move distributor slight to align timing marks
What Type of refrigerant is used in a 1996 Ford Contour?
This is the transition year. It can be R12 or R134. It is listed on the unit. The fact that R12 is no longer being produced makes it extremely expensive. Convert it to R134.
What is the function of control a?
The function of a control unit is to provide control signals and timing to direct the operation of other units. The control unit manages all of the computer resources and it directs the data flow between your devices and the Central Processing Unit.
